A new home comes with a new set of bills and a lot of unknowns. How old is the AC? Is the attic insulated? Why is the first electric bill so much higher than at your last place? The first few months are the best time to find out, while you still have the inspection report handy and before small problems turn into expensive ones.
This checklist is organized by when to do each item. Most of it costs little or nothing.
Week 1: Learn the house
Find the shutoffs
Locate the main water shutoff, gas shutoff, and electrical panel. Label circuits in the panel if they aren't labeled. Knowing these in an emergency can save thousands in water damage.
Read the inspection report again
Highlight anything related to HVAC, the roof, water heater, insulation, windows, electrical and plumbing. Note the ages the inspector recorded. Make a list of items flagged as "near end of life" or "monitor."
Record equipment ages
Check the data plates on the AC or heat pump, furnace and water heater. The manufacture date is usually in the serial number. Write down: - AC or heat pump: most last 12 to 15 years. - Furnace: 15 to 20 years. - Tank water heater: 8 to 12 years. - Roof: asphalt shingles 20 to 30 years.
Anything near or past those ranges belongs in your budget for the next few years. See how long an AC lasts and how long a roof lasts.
Set up utility accounts and look at rate plans
When you open accounts, ask about rate options: time-of-use, budget billing, and any programs for smart thermostats or demand response. In deregulated states like Texas, Pennsylvania and Ohio, compare retail electricity plans before the default plan locks in.
Month 1: Quick, cheap wins
Change the HVAC filter
You don't know when the last owner changed it. Check the size on the old filter and stock up. Plan to change it every one to three months.
Program the thermostat, or replace it
Set heating and cooling schedules around when you're home. If the thermostat is old or manual, a smart thermostat often pays for itself within a year or two. Some utilities offer rebates or bill credits for them. See smart thermostat savings.
Set the water heater to 120°F
Many are set higher. 120°F is hot enough for most households, reduces scalding risk, and saves energy.
Switch to LED bulbs
Replace any remaining incandescent or halogen bulbs, starting with the fixtures you use most.
Look for obvious drafts
On a cold or windy day, feel around exterior doors, window trim, outlets on exterior walls, and the attic hatch. Weatherstripping and caulk are inexpensive and easy to apply.
Check smoke and carbon monoxide detectors
Test each one and replace batteries. Replace detectors older than 10 years. If the home has gas appliances or an attached garage, make sure there's a CO detector on each floor.
Month 2: Look deeper
Get your first bills and compare
Compare your kWh and gas usage with your state's average (see average electric bill by state) and, if possible, with the previous owner's history. Some utilities share 12 months of past usage for an address. A big gap is worth investigating.
Check the attic
Look at insulation depth. In most of the country, the Department of Energy recommends about R-38 to R-60 in an attic, which is roughly 12 to 20 inches of blown or batt insulation. If you can see the tops of the ceiling joists, you probably need more. Check for daylight, water stains and signs of pests. See attic insulation ROI.
Inspect ducts you can reach
In the attic, crawlspace or basement, look for disconnected, crushed or uninsulated ducts. Gaps at joints are common and easy for a pro to seal.
Schedule an HVAC tune-up
A technician can check refrigerant charge, clean coils, test safety controls and give an honest read on remaining life. Ask them to note the system's condition in writing for your records.
Flush the water heater
Sediment builds up in tank water heaters and reduces efficiency. Draining a few gallons from the bottom valve once a year helps, unless the tank is very old, in which case flushing can stir up leaks. Ask a plumber if unsure.
Month 3: Plan the bigger projects
Get a home energy assessment
A professional energy audit with a blower door test shows exactly where the house leaks air and loses heat. Some utilities offer free or discounted audits. You can also start with a free HomeShark report, which estimates where your home is likely losing energy based on its age, size and systems.
Prioritize upgrades by payback
In most homes, the order looks like this: 1. Air sealing and attic insulation. 2. Duct sealing. 3. Replacing HVAC or water heater equipment at end of life with efficient models. 4. Windows, solar and batteries, depending on goals and budget.
See our home energy efficiency checklist for 25 steps ranked by return.
Build a replacement budget
Using the ages you recorded, estimate when each major system will need replacing and set money aside. Replacing equipment on your schedule, rather than in an emergency, saves money and lets you compare quotes.
Check for local programs
Federal homeowner energy tax credits ended after 2025, but many utilities still offer rebates for insulation, heat pumps, heat pump water heaters and smart thermostats. Some states run income-qualified Home Energy Rebate programs. Availability changes, so check your utility and state energy office.
Ongoing maintenance calendar
| When | Task |
|---|---|
| Every 1–3 months | Change HVAC filter |
| Spring | AC tune-up, clean outdoor coil, clear gutters |
| Fall | Furnace or heat pump tune-up, check weatherstripping, clear gutters |
| Yearly | Test detectors, flush water heater, check attic and roof after storms |
| Every 2–3 years | Have ducts and refrigerant lines inspected |
Frequently asked questions
What should a new homeowner do first to save energy?
Change the HVAC filter, program or upgrade the thermostat, set the water heater to 120°F, switch to LED bulbs and seal obvious drafts. These cost little and take effect immediately.
Why is my first electric bill in a new house so high?
Common reasons include a larger home, different heating fuel, an older or failing HVAC system, poor insulation, a higher rate plan, or a longer first billing period. Compare kWh usage, not just the dollar amount.
Should I get an energy audit after buying a house?
Yes, especially if the home is more than 20 years old. An audit identifies air leaks and insulation gaps that a standard home inspection doesn't measure.
How do I find out how old my AC or water heater is?
Look at the data plate on the unit. The manufacture date is usually printed or encoded in the serial number. The manufacturer's website or a technician can decode it.
What home energy upgrades pay back fastest?
Air sealing, attic insulation, a smart thermostat and LED lighting usually pay back fastest, often within one to three years.
What maintenance does a new home need each year?
HVAC tune-ups, filter changes, gutter cleaning, detector tests and a water heater flush cover most of it.
Should I replace an old water heater right after buying a house?
Not necessarily. If it's over 10 years old, plan and budget for a replacement so you can choose an efficient model instead of an emergency swap.